Pallet Backstop Beam
A full-width steel backstop across the rear of a bay, set to give a consistent 6″ load offset, so pallets stop in the same place every time instead of being pushed past their spot into the flue space or off the back of the rack. Its end brackets drop straight into the upright holes and lock with a built-in piston lock, with no bolts or tools. Made for Interlake Mecalux teardrop rack, 96″ wide.
Technical Specifications
Related products
A steel stop that slides onto the rear beam and physically limits how far a pallet can be pushed into the bay. It stops the two failures that follow over-travel: product pushed off the back of the rack, and pallets driven into the flue space where they block sprinkler penetration. Flush, 3″ and 6″ overhang versions suit different load depths, and it also holds waterfall wire deck in place on a 1-3/4″ × 1-3/4″ mesh grid.
- Fits beam: 2-3/4″ deep × 4-3/4″, 6″ or 6-1/2″ face
- Versions: Flush · 3″ overhang · 6″ overhang (6-1/2″ face only)
- Back stop: 5″ high × 1-3/4″ wide
- Install: Slides over the rear beam; bolt-through or Tek screw
A floor-anchored stop for the ground-level bay, where there is no rear beam to hang a pallet stop from. The standard stop is a 7″ × 6″ × 4″ block in 3/8″ steel, anchored behind the load so a pallet cannot catch on it, fixed with two 1/2″ × 3″ concrete anchors. A slimmer 8″-tall version, 2″ wide with a gusset behind it, does the same job of stopping a pallet short of a back wall.
- Standard: 7″ W × 6″ H × 4″ D, 3/8″ thick steel
- Slim: 8″ H × 2″ W, gusset-braced, 1/4″ steel
- Anchors: Standard: two 1/2″ × 3″ Tapcon anchors, behind the guard
- Use: Ground-level bays with no rear beam
Warehouse safety netting for pallet rack: woven mesh that spans the back or ends of a bay to catch product and debris before it falls into aisles or onto pedestrians, which is the secure-storage duty OSHA 1910.176(b) puts on you. It hooks to standard teardrop or slotted uprights and keeps the longitudinal flue space clear for sprinklers. Standard bay sizes stock from 8′ to 13′ wide, with custom and offset versions for overhanging loads.
- Type: Woven-mesh rack guard / debris net
- Function: Catches falling product/debris off the back or ends of a bay
- Mounting: Hooks to standard teardrop or slotted uprights
- Sizing: Standard bay widths, with custom and offset versions
Let our engineers spec it.
Send a rack drawing or a photo. We'll return a per-bay layout with quantities, install notes, and a detailed quote.


